SOHC.co.uk Forums > CB350/400
CB400/4 rear hub bearing retainer
Nurse Julie:
I have a spare rear hub here that I'm going to refurb but which way does the bearing retainer undo?. I have looked in Haynes and the Shop Manual but it makes no mention. Does this lack of mention mean it undoes the normal way, or is it a back to front thread, so......left or right to undo?
AshimotoK0:
It's normal RH thread Julie ..the only LH thread I have found on a Honda was on the 500/4 and it's steel on that one.
I removed a couple of 400/4 retainers last week ... I made the mistake of not drilling out the staking indents enough on the 1st .. second was dead easy once drilled deep enough.
Nurse Julie:
Thanks Ash. I can now start whacking the removal tool in the right direction ;D
paul G:
--- Quote from: Nurse Julie on October 16, 2018, 03:37:21 PM ---Thanks Ash. I can now start whacking the removal tool in the right direction ;D
--- End quote ---
You and Graham not talking ;D ;D ;)
Nurse Julie:
--- Quote from: paul G on October 16, 2018, 03:52:02 PM ---
--- Quote from: Nurse Julie on October 16, 2018, 03:37:21 PM ---Thanks Ash. I can now start whacking the removal tool in the right direction ;D
--- End quote ---
You and Graham not talking ;D ;D ;)
--- End quote ---
No Paul, Incommunicado as they say. He is in mass engine stripping / prepping /building mode and I am in rear hub mode. From a conversational point of view they are totally incompatible, I am wanting to talk huge hammers and he is mumbling on about so many 'thou of a 'thou, so, on my own with this one ;D ;D ;D
Navigation
[0] Message Index
[#] Next page
Go to full version