SOHC.co.uk Forums > CB350/400

Fork lowers original finish?

<< < (3/6) > >>

Sprocket:

--- Quote from: Oddjob on October 18, 2018, 01:43:12 PM ---Julie, the gap in the fork clamp is supposed to be at the back not the front
--- End quote ---
So, interesting find number #3856433/23b. The fork end clamp pieces are asymmetrical. There's about a 2mm difference between the shoulders. If the gap is supposed to be on the rearmost stud, does it follow that the shorter shoulder should also be on the rearmost stud?

Nurse Julie:

--- Quote from: Oddjob on November 19, 2018, 09:32:03 AM ---Fairly sure there is an arrow embossed in the bottom of them which points forward if installed correctly.

--- End quote ---
No arrows on mine Ken but Graham says some do, some don't.

Sprocket:
So, any idea which shoulder faces the wind then?

Bryanj:
The clamps have an arrow on them that faces forward and the front stud is done up first

taysidedragon:
The high shoulder is at the front

Navigation

[0] Message Index

[#] Next page

[*] Previous page