SOHC.co.uk Forums > CB350/400
Carburettor Insulators
Laverda Dave:
The numbers are raised and are on the edge of the rubber where the butt up against the carbs. So in other words you'll need a giraffe's neck to see them and the carbs are also likely to block any view.
I fitted a new set to my 400/4 bought from DS. I didn't see markings when originally installing them and it was only after struggling to fit the carb bank when I looked again and noticed the faint, raised numbers. I think they were numbered 1 to 4.
Nurse Julie:
All 4 of mine have a flat spot on both top and bottom, simple when you think about it, you wouldn't be able to get the screws in there if the flat spot wasn't there. No idea if mine have numbers, eyes not that good 😀😀😀
[ Guests cannot view attachments ]
Athame57:
--- Quote from: Nurse Julie on October 25, 2018, 10:14:54 AM ---eyes not that good 😀😀😀
(Attachment Link)
--- End quote ---
Surely you don't (or didn't) drive a Cortina?
Nurse Julie:
--- Quote from: Athame57 on October 25, 2018, 10:36:10 AM ---
--- Quote from: Nurse Julie on October 25, 2018, 10:14:54 AM ---eyes not that good 😀😀😀
(Attachment Link)
--- End quote ---
Surely you don't (or didn't) drive a Cortina?
--- End quote ---
😀😀😀😀😀
Laverda Dave:
I've just had a rummage through my old parts box and found the insulators. Apologies for the poor photo but the camera wouldn't focus..... Anyway, the number is on the insulator to the right of the fixing hole. They are numbered 1-4. I assume they are fitted with the number at the top. This will mean you cannot see numbers 1&2 as they will be obscured but you should see 3&4 as they will be on right hand side of the mounting set screw.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version