SOHC.co.uk Forums > CB750

K7 exhaust gaskets.

(1/2) > >>

Phil A:
I think I know the answer to this, but just in case I’m going to ask anyway.
I took the exhaust off, one side, so I could refit the centre stand. I thought it might be difficult to remove but the nuts came undone very easily. There is no copper gasket/ oring fitted. The exhaust fitted is an aftermarket 2 - 1. I’m not sure of the make.
So my question is should I fit copper gaskets when I refit the exhaust?

hairygit:
Yes, probably meant to be there but whoever fitted the pipes didn't bother!

Sent from my X6pro using Tapatalk

Phil A:
That’s what I’m thinking to.

Bryanj:
If you look closely they are there but look like carbon and probably as hard as concrete

Phil A:

--- Quote from: Bryanj on October 29, 2018, 01:03:06 PM ---If you look closely they are there but look like carbon and probably as hard as concrete

--- End quote ---

You’re right I didn’t look closely enough. I have managed to get them out so can fit new ones. Thanks.

Navigation

[0] Message Index

[#] Next page