SOHC.co.uk Forums > CB750
CB750F1 Valve guide reaming
martin_uk:
Assume normally ream from combustion side?
martin_uk:
The reamer has arrived and is a close fit on the non replaced guides, but does not have a lead in.
Without a lead in, concerned that it will be difficult to correctly align.
The finished size needs to be 6.6mm. I have seen Chinese adjustable reamers, but not sure about quality and will take quite a few weeks to arrive
As an alternative, has anyone had guides reamed and can recommend a company in the South?
Laverda Dave:
You could try J D Autoworx based in Wallington.
Bryanj:
If there is no lead on the reamer sounds like a machine one instead on a hand one
martin_uk:
--- Quote from: Laverda120 on December 02, 2018, 07:38:48 PM ---You could try J D Autoworx based in Wallington.
--- End quote ---
Thanks I will give them a call
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version