SOHC.co.uk Forums > CB350/400

no power under load

<< < (3/3)

ricardo:
Thanks Julie.

I'll do it assign as it stops raining

Chris whit:
Hi Ricardo , i had a similar problem after getting my carbs back from being refurbished from Gerben in the Netherlands. Bought a set of balance gauges and balanced the carbs up , also check your valve clearances .
Mine runs sweet as a swiss watch.

ricardo:
Hi Chris.
Its gives me hope thanks. I'll put bike aside to hibernate for the winter and take your advice if I'm still troubled.
Ricardo

billywingnut:
Have you checked the plug caps? I measured the resistance on mine they are usually about 3500 ohms  (3.5kohms), one was measuring over a meg ohm ( 1,000,000) so I replaced the lot and plugs. People are saying buy the none resistor type spark plugs, Check the points and replace if necessary. My bike will not run smooth without the air filter in place with a good lid on the filter box. I think it's a good idea to buy an inexpensive compression tester if you have never tested it you could have valve issues. I don't mean to scare you should be prepared to put some  work in and learn new skills to get it running correctly, it's worth the trouble

Navigation

[0] Message Index

[*] Previous page