SOHC.co.uk Forums > Project Board
1976 CB550F1 (what have I let myself in for) Project
eight0:
Thanks to OddJob i finally have the bearings I need.
Been busy zinc plating the case bolts and washers and got most of the internals assembled. Before I attempt to mate the cases, can anyone see anything incorrect?
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]
Bryanj:
Is that the transmision oil pump hole i can see on a needle brg or the dowel not located? Knowing you i suspect the former but have to ask
eight0:
The bearing is located in the dowel. That's the transmission oil pump hole. That's correct right?
Bryanj:
I do more 500 than 550 and that is one of the few differences so just being super aware is all
eight0:
Thanks Ken. Yeah I hadn't added the crank at the point I took the photos.
Here it is as it stands now
[ Guests cannot view attachments ]
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version