SOHC.co.uk Forums > Project Board
1976 CB550F1 (what have I let myself in for) Project
eight0:
Might be, but There's bits of metal in there.
Mm no not gasket seal, I used very little hondabond anyway. Those bits on my finger are metal and magnetic. :(
eight0:
What do you think it is? I guess its hard to know. I didn't try to run it with the kick start in bits so it's not that.
K2-K6:
Looks like it's broken off something (staing the obvious from me ::) )but appears to be bent and of softer material, that's as opposed to geabox teeth that usually chip off and retain their form.
Might be worth rinsing it and giving us a clearer picture on white paer to get a better look and see if someone can give more positive I'd.
It "looks" more like kickstart component initially and could be a bit sheared from there as it's quite a high torque right down in the centre of leverage, that's most likely to be related to what you felt when using the lever.
K2-K6:
Oops, lost a pee in that "paer" up there :)
Obvious or not, but PAPER.
Got it that time ;D
eight0:
Ha yeah got it.
Ok yes it's not the best picture. There were more smaller bits in the sump, like crumb size if that makes sense. Not loads, but as I only ran the bike for 1 min max, enough.
I'll wash as much as I can and put it on some paper and get a better picture. My fear is bearing but not sure what could cause that so quickly.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version