Author Topic: Box section swing arm? (Read 5201 times)

Arch stanton · « **Reply #30 on:** December 29, 2018, 03:25:56 PM »

25mm of shoulder & 20mm of thread. = 45mm overall.
Hope this is of assistance.
Sean. If

SamCR750 · « **Reply #31 on:** December 29, 2018, 05:29:07 PM »

I thought it might be but wasn't 100% sure, it is the same as all the early Ks.
It's just the late Ks, F2 and Autos that have it longer on the drive chain side.

Arch stanton · « **Reply #32 on:** December 29, 2018, 09:08:22 PM »

I wonder why that was?

SamCR750 · « **Reply #33 on:** December 29, 2018, 10:29:05 PM »

I can only guess Sean as I never measured it but I'm guessing the gearbox sprocket is about 5/8th of an inch further out on the shaft.
On all the later models, everything is cranked out on the near side.
I'll see if I can find a picture of the problems I had when I tried to fit a K swingarm into an Auto frame.

SamCR750 · « **Reply #34 on:** December 29, 2018, 11:02:48 PM »

Sean, look at the angle of the left rear strut, this is what happens when you mix early with later model parts.
Can you imagine IF you could get a shock to fit, the problems it would have going up and down.

Arch stanton · « **Reply #35 on:** December 30, 2018, 08:53:53 AM »

Was there any particular reason for using a A frame!?

SamCR750 · « **Reply #36 on:** December 30, 2018, 07:30:25 PM »

It was all Automatic apart from the swingarm Sean.

Honda-SOHC

News:

Author Topic: Box section swing arm? (Read 5201 times)

Arch stanton

Re: Box section swing arm?

SamCR750

Re: Box section swing arm?

Arch stanton

Re: Box section swing arm?

SamCR750

Re: Box section swing arm?

SamCR750

Re: Box section swing arm?

Arch stanton

Re: Box section swing arm?

SamCR750

Re: Box section swing arm?