SOHC.co.uk Forums > CB350/400
Carb work
mattsz:
--- Quote from: blackeagles on February 14, 2019, 12:04:07 PM ---
--- Quote from: mattsz on January 20, 2019, 02:57:10 AM ---
I have both. Interesting that the Honda service manual doesn't mention the needle grooves...
--- End quote ---
if you have the 'shop manual - honda cb350f-400f' (hwm002) by honda then its right at the back on page 95!
--- End quote ---
Yes, you're right, of course - I did notice that. I wasn't clear, what I meant was, that I thought it interesting that that manual doesn't mention the grooves at all in the work description...
Bryanj:
Keyster kits are not good for brass bits which rarely wear but usually have all the gaskets and O rings
Dave487:
I think you'll always get black sooty plugs if you're just checking them after idling as they don't hot enough to burn it off.
Bryanj:
Also forgot to say 500's do run rich low down.
mattsz:
Someone gave me a carb jet cleaning tool. Bikemaster says it's a necessity. Is this useful, or should I avoid it like the plague?
https://bikemaster.com/carburetor-jet-cleaning-tool.html
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version