SOHC.co.uk Forums > CB350/400
400/4 restoration - it begins at last
Sprocket:
I'm a couple steps behind you! Saw this on eBay (https://www.ebay.co.uk/itm/Honda-Clutch-Holding-Tool-Centre-Nut-Tool-Set-CB400F-400-Four-400-4-HWT051-/251421804669) and wondered whether or not it's really necessary. The vids I've seen on YouTube seem to suggest you don't need a special tool, just a castellated socket.
Thoughts please, experts?! :D
Nurse Julie:
Castelated socket should work just fine 👍
Bryanj:
The special tool is a castellated socket!
Rozabikes Tim:
Yes I have a proper Honda one somewhere and will order one if it does not turn up before rebuild. Just impatient and want to do more on the weekend. Its so exciting!!! ::)
Rozabikes Tim:
Well frame all stripped and everything boxed up for later assesment.
Motor all apart besides 5 head studs. I have done the 2 nut / heat trick on all but these last ones are reluctant. They are quite thin shanked and I do not want to apply too much force and break them..... Think I will try stud in vice and turn the whole case - (Laverda120's tip I think?) Will apply heat again but worry I may go overboard with too much! Any guidance appreciated.
Edit Ocadians vice tip - ta Julie :D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version