SOHC.co.uk Forums > Project Board
CB350F Rusteration
JamesH:
Coming along very nicely. Like where you're going with this..:-)
Moorey:
Thanks James, still undecided what to do with the exhausts though. :)
Moorey:
Just to add a bit of interest to the job the bike lift decided to break down when in a position that made it impossible to get at the ram and mechanism. All sorted once I managed to get to the ram now goes up and down like a good un again. :)
Moorey:
A bit more progress today. Sorted out the deformed and grey looking airbox with the use of a hot air gun.
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]
Carbs back in and new cables. What a pain in the arse getting the carbs back in. A lot worse than doing the 750. Is there a easy way. Am I missing a trick somewhere.
[ Guests cannot view attachments ]
New internals in the petrol tap tank back on and seat with new cover. There are a couple of dings in the tank that I will try to remove when I can get to make something to try and press them out from the inside.
[ Guests cannot view attachments ]
Moorey:
New plugs and caps. Whilst they were out checked the compression.
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]
[ Guests cannot view attachments ]
Plugs back in, swilled the tank out with diesel, put some petrol in the tank and away it went. I have 1 float bowl leaking on the gasket. Bugger. I hoped I would get away with re using them. New ones now coming. :) I obviously need more practice with them carbs anyway.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version