SOHC.co.uk Forums > CB750

Rebuilding carbs, need some advice!

(1/2) > >>

xriccix:
First job I want to get sorted is the carbs. This is the set that came with the bike, from what I can see right off the bat there are a few missing bits, a couple of nuts, throttle return spring and the bottom connector for the throttle return spring, I cannot seem to find a name for the damn thing or where to buy one??



Apart from being filthy the carbs look good, took the bottoms off and looks clean inside, I'm still debating a full rebuild. I guess it will come down to if i used a bread box or velocity stacks and therefore might need to use different jets.*

Bryanj:
Plate spring setting 16066-300-004

xriccix:

--- Quote from: Bryanj on March 04, 2019, 10:52:21 PM ---Plate spring setting 16066-300-004

--- End quote ---

Perfect thanks! Now just to find one in the uk!

xriccix:
In regards to the above set of carbs, I'm planning on taking of the mount and giving then a good clean. I might paint the bowls and round tops black, im not sure yet.

What would be the best way to clean the crap off, just degreease and a stiff brush?

Rob62:
They should clean up quite easily with degreaser and a bit of metal polish... the bowls usually come up very bright with a bit of a polish.. no point going mad with the polishing though, as they will soon tarnish and settle back down to a standard greyish look. With some fresh rubber boots and bright hose clips they will look great.

Navigation

[0] Message Index

[#] Next page