SOHC.co.uk Forums > CB350/400

Video rebuild

(1/6) > >>

Greg65:
As I never did an apprenticeship or worked in the trade I sometimes found the Haynes manual assumes more knowledge than I possess. Julie’s rebuild has been a wonderful boost and various post have helped however when I was faced with a bench full of clean bits I was definitely nervous about getting it right. Whilst reading the manual again and pondering how to start my son asked me when I would get on with it. So explained my fears, “oh” he says, fingers tapping on his smart phone, there is a you tube video if it’s any good.

This is it. https://m.youtube.com/watch?v=vR-MiqdHi1w

Now I’m sure it’s not perfect but it really helped. So I was wondering, we have a wealth of knowledge on this forum and a lot of people who would like to know how. Would it be possible for a series of SOHC “approved “ on how to xyz be done. It would be a shame to lose the knowledge.

SteveD CB500K0:
Interesting.

I'd be happy to put links in Aladdin's Cave (as long as Julie says these vids are OK :))

Nurse Julie:
I think it's a great idea. The problem is that everyone builds engines slightly differently and uses different processes and methods and who is to say what is correct or incorrect. I think if we are going to have them in Aladins Cave, it should be pointed out that the person recommending the video has his / her name put to it saying they found it useful as a resource.

Trigger:
Those vids have been kicking about for a couple of years and contains quite a few NO, NO's if building a engine  ;)

hairygit:
Why not let Julie video YOU doing some rebuilds then Trig, that way people can be sure it's the right way to do it!

Navigation

[0] Message Index

[#] Next page