SOHC.co.uk Forums > CB350/400
3d print files?
Rob62:
Yeah I would have thought they are available as injection moulded reproductions... a 3d printed part will be a poor substitute (rough finish) unless you have a bloody expensive printer.. but i’ll happily do a cad model.....
SumpMagnet:
The 750 one is the same? well...I DO have one of those in the shed on my switchgear. I will have to dig it out and measure it up
Nurse Julie:
--- Quote from: SumpMagnet on April 16, 2019, 07:35:41 PM ---The 750 one is the same? well...I DO have one of those in the shed on my switchgear. I will have to dig it out and measure it up
--- End quote ---
It may only be UK models that have that type of knob across the model range. I think USA switch gear knobs are different. Don't know about 750 F1/2's as don't have any if them models here.
SumpMagnet:
hmm...will have a look and see. My F2 came across the pond...so jury is out
Nurse Julie:
--- Quote from: Oddjob on April 16, 2019, 09:13:43 PM ---
--- Quote from: Nurse Julie on April 16, 2019, 06:53:16 PM ---
--- Quote from: Sprocket on April 16, 2019, 06:50:47 PM ---That's the little bit yes! If you could take as many pics as possible, perhaps put it on a flatbed scanner, I'm sure that would be a good way to start!
Thank you! :)
--- End quote ---
OK Barry, I will do it on Thursday
--- End quote ---
Careful Julie, the little screw which holds it on can't round off very easily.
--- End quote ---
Thanks Ken. I have had the knob off before as a wire had corroded in the switch and i soldered it back together. What I'm not sure about, as i can't remember, is if i put a dab of locktite on the screw but, i will have a look and see before I wade in.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version