SOHC.co.uk Forums > CB350/400
3d print files?
Nurse Julie:
Is it just the plastic knob you are all talking about?. If so, i have one on my bike that i can remove and take photos of and measurements if needed. But, not until Thursday as busy tomorrow.
This thing
And no, the bike still hasn't been cleaned !!! You can tell my bikes are riders and not show ponies 😀😀😀
[ Guests cannot view attachments ]
Sprocket:
That's the little bit yes! If you could take as many pics as possible, perhaps put it on a flatbed scanner, I'm sure that would be a good way to start!
Thank you! :)
Nurse Julie:
--- Quote from: Sprocket on April 16, 2019, 06:50:47 PM ---That's the little bit yes! If you could take as many pics as possible, perhaps put it on a flatbed scanner, I'm sure that would be a good way to start!
Thank you! :)
--- End quote ---
OK Barry, I will do it on Thursday
Rob62:
Hi Julie, if you take photo’s or scans try to include a digital caliper so the size can be accurately reproduced :o
Nurse Julie:
--- Quote from: Rob62 on April 16, 2019, 06:56:42 PM ---Hi Julie, if you take photo’s or scans try to include a digital caliper so the size can be accurately reproduced :o
--- End quote ---
Yep, I will be armed with appropriate measuring equipment.
Someone makes them somewhere as they are fitted to all the replica switchgear. It's the same knob on 500/4, 550/4 and 750/4
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version