SOHC.co.uk Forums > CB350/400

Raask rear sets for 400/4

<< < (2/2)

billdn:
Hi Ken,
a picture says a thousand words and both sides now installed thanks to your pictures. However I don't see the significance/ purpose of the spring that goes around the rear brake pedal mounting, does it go under the pedal or over it's not quite clear in your photos also I find that when I depress the brake pedal it doesn't spring back/return - I'm guessing a small assembly error on my part. the rear brake spring that fits inside the frame carrying the brake rod is fitted also returns if I lift the pedal up.

Any ideas ? But thanks again for coming to my aid, restored my faith in the forum principle!

ka-ja:
Hi Billdn,
             From memory the only spring on my setup is the original 400/4 return spring,I have however, changed my rear brake to cable operation, solely because of the braced box section swingarm, that may make the lever return better??? I will pm you when I return home later this week.

Navigation

[0] Message Index

[*] Previous page