SOHC.co.uk Forums > CB750
K1 carb question
Nurse Julie:
They look great Mick.
Crispy:
Cheers Julie, they look a lot better than they did that's for sure. I can now start to put the carbs back together again. I have one set of floats that has a leak but apart from that and gaskets,after a good clean everything else seem fine!
Crispy:
Just looking at the carburettor gasket kits on DS website, he does a Honda one and an aftermarket set at nearly half the price of the Honda set, anyone used the aftermarket one? They ok? This is just the o rings and bowl gaskets. Cheers :)
JamesH:
--- Quote from: Crispy on August 02, 2019, 12:35:11 PM ---Sorted!
--- End quote ---
Very nice - mind sharing who did those for you?
Crispy:
--- Quote from: Jamesh_sussex on August 15, 2019, 10:38:24 AM ---
--- Quote from: Crispy on August 02, 2019, 12:35:11 PM ---Sorted!
--- End quote ---
Very nice - mind sharing who did those for you?
--- End quote ---
It was Allenchrome who did them after all. At first they said over the phone that they couldn't do them but I called in on my way home after a weekend in York to collect my zinc plated parts and spoke to a bloke called Dave who after examining them again said he would have a go at doing them and post them back to me. I was expecting to wait ages for them but I was very surprised to get them back after only 4 days! Cost was £35 inc postage . They have always been pretty efficient but that was very quick! I suppose they had already had them for 5 weeks though with the rest of the stuff I sent for zinc plating! :o
Navigation
[0] Message Index
[*] Previous page
Go to full version