SOHC.co.uk Forums > CB750

K1 carb question

<< < (2/3) > >>

Crispy:

--- Quote from: Trigger on May 13, 2019, 10:05:55 PM ---Loads of little parts on these and don't lose the crush spacers on those top 3 bolts and the screw  ;)

--- End quote ---

Cheers Graham, I'll look out for them now I know they are there!   :)

Crispy:
Graham, Help!  :) where did you get your carb parts plated?  I'm picking my carburettor parts up from Allenchrome next week, they've done all the zinc plated parts but say they can't do anything with the two (alloy?) throttle lifter fittings that are part of the plate set (part 18 parts manual). I asked Allenchrome to chrome plate them but apparently they can't do them.  >:(
Any recommendations as to where I could get these two items sorted?  Yours look nice and shiny!

Trigger:
I had mine done many moons ago and can't remember where. I can remember they were about £50.
You will need to find a firm that chromes alloy. A lot of places stopped chroming alloy years ago, like in the 80's everyone did black chrome but, can't find anyone that does that anymore.

Crispy:

--- Quote from: Trigger on July 27, 2019, 08:43:38 PM ---I had mine done many moons ago and can't remember where. I can remember they were about £50.
You will need to find a firm that chromes alloy. A lot of places stopped chroming alloy years ago, like in the 80's everyone did black chrome but, can't find anyone that does that anymore.

--- End quote ---
Cheers Graham, I'll investigate further then!  :)

Crispy:
Sorted!

Navigation

[0] Message Index

[#] Next page

[*] Previous page