SOHC.co.uk Forums > CB350/400

renewing front bearing

(1/2) > >>

ricardo:
Hello again.

I'm preparing to replace the front wheel bearings. One of the workshop manuals says pack the bearings AND the hub with grease.

The ones I removed seem to be sealed and filling the hub with grease will take an hour. Also there was no grease in the hub when I took it apart.

Ricardo

ka-ja:
I used to remove the inward facing seal on wheel bearings and 1/2 pack the centre section with grease, double sided seals on bearings can mean they are only oiled

Trigger:
Just use good quality bearings NTN 6302 2RS  ;)

ricardo:
thanks bikers

gtmdriver:
If you use aa good quality double sealed bearing you can just fit them as they are and leave the hub cavity dry.

Navigation

[0] Message Index

[#] Next page