SOHC.co.uk Forums > CB350/400

front wheel bearing spacer. Help Julie!!

(1/2) > >>

ricardo:
which way round does it go. One end has flat flanges and the other curled

Nurse Julie:
It should look like this Ricardo. The lugs are bent on yours as its a lock washer and its the tabs that lock. Off the top of my head, i don't know which end goes which side but it should be self explanatory.
[ Guests cannot view attachments ]

Nurse Julie:
Interested to know how you removed the front axle without opening the tabs 🤔🤔

ricardo:
Thanks Julie.
I seem to recall that is I dismantled the parts the axle just pulled  out after the outer bits were removed (it was firmly fixed)
After that I was faced with the 2 bearings. The r side was removed and then the spacer just slid out. I then removed the L side bearing

I have the same number of parts as shown on the blown up drawing.
I intending putting the L side bearing back first as it has a seat cast into the hub. then insert the spacer then fit the r side bearing. Should I use the axle to guide it in some way??
Ricardo

ricardo:
Actually mine doesn't look like that. One end definitely has curled flanges as if they were twisted down.
Maybe that happened when I took the bearings out. I banged a lot.
Ill buy a new one

Navigation

[0] Message Index

[#] Next page