SOHC.co.uk Forums > The Black Bomber Board

Black Bomber valve clearances.

<< < (4/7) > >>

sye:
Can Newman not build up the follower and regrind?

royhall:
They would normally weld on a pad, but by the time two way postage plus costs of the job are added up I may as well buy a new one. I doubt they would have the correct dimensions to work to either. Plus last time it was a two month wait.

Bryanj:
So the gap is too big?

royhall:

--- Quote from: Bryanj on June 28, 2019, 12:09:21 PM ---So the gap is too big?

--- End quote ---
Way too big.

K2-K6:
It looks like they're not familiar with that adjustment geometry specific to this engine at Newman. With a conventional screw type it could accommodate that change.

Worth taking into consideration for anyone else in same situation,  unfortunately of little help here.

Navigation

[0] Message Index

[#] Next page

[*] Previous page