SOHC.co.uk Forums > CB350/400

Original CB400/4 parts availability

<< < (3/4) > >>

royhall:
Bit hit and miss really. Some are good some are rusting in the box. Mine is okay but I have to keep on top of it. My mates is rusty as hell, same supplier. He's going to have it rechromed

Sent from my Pixel 3a XL using Tapatalk

THUNDERDOWNUNDER:
Yeah , front stay won’t fit .as you can see the back stay pushes the front down to far .I was thinking of drilling main bracket holes bigger to  get some movement . Crome looks good but undersealed it just in case .

Nurse Julie:
Try fitting the blade only to start with and only do fixings up very loosely, this gives you wiggle room. Then do the same with the stays, only very loosely and then go round and tighten everything up, it should all pull into place.

taysidedragon:

--- Quote from: THUNDERDOWNUNDER on July 04, 2019, 11:58:19 AM ---DSS front guard  doesn’t fit  properly. can’t get Front stay on . Emailed them and they say yes not an easy fit hmm ? Also switch gear for 400/4 Chinese the wires are different colours to original from Honda What’s that all about ?

--- End quote ---

This is probably a silly question, but are the front and rear stays the same length? Could they be slightly different and only work the other way around.?
I didn't fit any stays to my short aluminium guard so not familiar with the standard setup.
Good luck with the fettling. 🔧☺

taysidedragon:

--- Quote from: taysidedragon on July 04, 2019, 05:16:08 PM ---
--- Quote from: THUNDERDOWNUNDER on July 04, 2019, 11:58:19 AM ---DSS front guard  doesn’t fit  properly. can’t get Front stay on . Emailed them and they say yes not an easy fit hmm ? Also switch gear for 400/4 Chinese the wires are different colours to original from Honda What’s that all about ?

--- End quote ---

Ok, it was a silly question! I was just looking at NurseJulie's  400f in the out and about section and remembered that the rear stay has the cable guide slot in it. Duurrrr! 😕

This is probably a silly question, but are the front and rear stays the same length? Could they be slightly different and only work the other way around.?
I didn't fit any stays to my short aluminium guard so not familiar with the standard setup.
Good luck with the fettling. 🔧☺

--- End quote ---

Navigation

[0] Message Index

[#] Next page

[*] Previous page