SOHC.co.uk Forums > CB350/400

front axle hub assembly

(1/3) > >>

ricardo:
taking prior advice from many of you . I have removed the hub assembly and will now take the rest apart. I noticed the bearing retainer looked a bit proud. Should it be screwed in further>
photo attached

Athame57:

--- Quote from: ricardo on July 21, 2019, 03:41:17 PM ---taking prior advice from many of you . I have removed the hub assembly and will now take the rest apart. I noticed the bearing retainer looked a bit proud. Should it be screwed in further>
photo attached

--- End quote ---
I should be screwed until it is ashamed!

ricardo:
did you mean 'it should be screwed etc' ?

Bryanj:
They are normally flush, is/are the bearings seated properly?

ricardo:
Sorry crossed wires. You wrote " I should be screwed etc". I have no problems with that. naturally. well I removed the piece and inspected it and the seating of the bearings. It looked like the bearing was not fully seated 2 mm maybe. Also the the top od the thread was distorted due to use of the wrong tool. I bashed the bearings in successfully . I know not very scientific. cleared up the damage to thread and its pretty much ashamed now.

also I need to adjust the static pad. Ill do that tomorrow. The spring was very flaccid and seems to be useless. Should I replace this or is it of  trivial function

Ricardo

Navigation

[0] Message Index

[#] Next page