SOHC.co.uk Forums > CB350/400

Poor Cold Starting

<< < (2/3) > >>

taysidedragon:
Look in Aladdins Cave at top of page. In CB400 section.

CBNelly:
Thanks, I'll set up carbs as per manual and see what happens!

CBNelly:
Well, got my carbs back together after fitting new genuine jets, etc. form Mr Silver!

Have a question regarding set-up of the choke

When open should the choke flaps fully cover the inlet port or is there a particular way of setting them up?

Thanks!

 

Nurse Julie:

--- Quote from: CBNelly on August 18, 2019, 07:27:46 PM ---Well, got my carbs back together after fitting new genuine jets, etc. form Mr Silver!

Have a question regarding set-up of the choke

When open should the choke flaps fully cover the inlet port or is there a particular way of setting them up?

Thanks!

--- End quote ---
Yes, fully cover the ports when flaps are closed and all totally horizontal and level when open. Adjust using the adjusters.

CBNelly:
Thanks for response

Also have a question regarding setting up of the slides

Honda manual says should be 0-1mm from top of inlet port when throttle wide open

Not easy to adjust while holding throttle open against the spring, is there a measurement you can take from the bottom of the inlet when the throttle is closed?

I seem to recall someone using 1.5mm drill bits to measure this gap, is this right?

Thanks

Navigation

[0] Message Index

[#] Next page

[*] Previous page