SOHC.co.uk Forums > CB350/400
rear sprocket
Nurse Julie:
400/4 spindle fixed end nut
[ Guests cannot view attachments ]
500/750 spindle end
[ Guests cannot view attachments ]
rosco:
Who's right and Who's wrong That is the question??? lol TrickyMicky has an early 400 with footrests on the arm and his spindle is the same as mine His arm are closed ends Mine are open end So maybe i have the early style spindle with later style arm !!!!! Parts catalogue shows both type arms but only one type spindle?Don't know why ??
Nurse Julie:
--- Quote from: rosco on July 27, 2019, 09:24:23 PM ---Who's right and Who's wrong That is the question??? lol TrickyMicky has an early 400 with footrests on the arm and his spindle is the same as mine His arm are closed ends Mine are open end So maybe i have the early style spindle with later style arm !!!!! Parts catalogue shows both type arms but only one type spindle?Don't know why ??
--- End quote ---
Just been looking in to this Ross. Both you and I have F2's which have the open ended swing arm, which we both have. Up to VIN number 1065686 (so a lot earlier than ours) they had the spindle with the big chrome end on, with the hole, which is the one you have I assume. This style was a hangover from the CB350/4's of earlier years. After the above VIN, they fitted the fixed bolt type, like I have fitted on mine and what you should have fitted on yours. Why Michael has a closed end swing arm, I have no idea as all 400's were manufactured with the open end type, again, a hangover from the CB350/4. I'm sure it makes no odds which is fitted really as long as it does the job.
Moorey:
--- Quote from: hairygit on July 27, 2019, 06:31:20 PM ---
--- Quote from: Moorey on July 27, 2019, 03:44:42 PM ---
--- Quote from: Nurse Julie on July 27, 2019, 03:11:10 PM ---Scrap that..my 400 does have an open end swing arm So, it doesn't matter which way the spindle goes in. (I was looking at the wrong bike 🤣🤣🤣🤣)
--- End quote ---
Shud av gone to spec savers. ;D
--- End quote ---
Not so sure that's a good idea!
Sent from my X6pro using Tapatalk
--- End quote ---
Good one.
rosco:
AS you say if it does the job I will fit it as i see fit, then fit exhaust, If it needs turning round no probs
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version