SOHC.co.uk Forums > CB350/400
rear sprocket
rosco:
Just had a look at DSS and they list two types The type i have (chrome end for tommy bar ) is for the F & F1 The long bolt type Julie has is the correct type / style for the F2 Although the parts manual lists this as fitting F & F2 So i guess they are interchangeable as the bearings are the same for both Ross
Nurse Julie:
--- Quote from: rosco on July 28, 2019, 10:39:51 AM ---Just had a look at DSS and they list two types The type i have (chrome end for tommy bar ) is for the F & F1 The long bolt type Julie has is the correct type / style for the F2 Although the parts manual lists this as fitting F & F2 So i guess they are interchangeable as the bearings are the same for both Ross
--- End quote ---
I wonder if both types are the same length overall Ross? Would be interesting to know just out of curiosity really. But, as you say, they both fit and do the job and that's all that matters.
rosco:
Picking my words carefully My rear wheel spindle measures from under the head a tad over 10.1/2 inches Approx Just under 27cm
taysidedragon:
--- Quote from: Moorey on July 27, 2019, 02:33:51 PM ---If you look in the Honda manual it shows the nut on the sprocket side . If the swing arm has open fork ends then it makes no difference which way the spindle is in as it doesn't have to be removed to take the rear wheel out.
--- End quote ---
Mooney is quite right. I'm sure the Clymer manual clearly says that on the 400f you remove and replace the whole rear wheel assembly without needing to remove the spindle and adjusters.
rosco:
Absolutely right TSD But the original question was which side the nut should be Sprocket or Brake And assuming theres room it won't matter which way its fitted The spindle type i have is with chrome end with use of tommy bar and wrong for the F2( although fits ) The F2 should be a long bolt type and seems Nut side to sprocket There is confusion within the parts book showing nut to sprocket and service manual showing nut to brake?? As i have no idea what the previous owner has done Just asking for clarification of nut position
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version