SOHC.co.uk Forums > CB750

Fitting Lower Tank Trim Strips

(1/1)

Andrew-S:
The original lower tank trim strips on my K1 are a bit too brittle and cracked in a couple of places (particularly one side) to refit against Menno's lovely new paint - although I am considering it as they have aged nicely, unlike me.......

I have bought replacement replicas from DS which are not quite the same profile, but if I do use them I assume these are easily moulded using the tank brackets - the question is: do I also use heat from a hairdryer or is this not needed?

Thanks,
Andrew

paul G:
Andrew, mine went on fine with no heat just following the contour of the tank.
You may need to trim them to fit as I did.

Andrew-S:

--- Quote from: paul G on September 18, 2019, 10:05:32 AM ---Andrew, mine went on fine with no heat just following the contour of the tank.
You may need to trim them to fit as I did.

--- End quote ---

Thanks Paul.

Navigation

[0] Message Index