SOHC.co.uk Forums > CB350/400
400/4 Exhaust Fitting Info needed
taysidedragon:
That sounds too tight. Are the pipes out of round and causing the binding?
If not you may need to remove a bit of metal to ease the fit. A gentle dremel round the inside of the collector pipes?
THUNDERDOWNUNDER:
Funny you should say that . I will try a socket on it tomorrow for roundness . If all ok will get the dremel out or lots of elbow grease with the emery paper ! Thanks for all the input guys !
THUNDERDOWNUNDER:
Just another thought on this . Why is there only one retaining clamp on the collector box ?
taysidedragon:
--- Quote from: THUNDERDOWNUNDER on October 27, 2019, 11:27:32 PM ---Just another thought on this . Why is there only one retaining clamp on the collector box ?
--- End quote ---
Good question. I guess it's cheaper to manufacture and when it's all assembled just one is enough, the others can't move.
THUNDERDOWNUNDER:
Problem fixed .slight lip on collector box inlets . Looked like build op of Crome platting . Filed it flush . Just have to assemble them now Agh !
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version