SOHC.co.uk Forums > CB500/550

cylinder head removal

(1/2) > >>

MIKE550/4:
78 550/4 k 3

Hi Guys

trying to do a top end rebuild, have taken rocker cover off, cam chain , ( hooked to stop falling into tunnel ) cam is out of bike, i have the haynes manual ( yeah i know ) , says this is clamped by 12 nuts, am i missing something here , i can only see 6, probably a noobie mistake

once these nuts are off i can imagine its going to be a job to release the head any tips ?

cheers mike

Seamus:
Download  from here:  http://www.sohc4.net/files/HSMCB500550.pdf

A good start. I did a 550 head a few years ago, and the head came off fairly easily. Have a look in the (downloaded) manual and you will find a diagram of the head bolt positions. I think you may have to remove the cam mounts to find some of the fixings. Note also that there are two fixings (front and back) that have to be removed from under the head (I mean from the cylinder barrel side)

Hope this helps

Good luck

Seamus

matthewmosse:
there are six rubber bungs to lift out plus 2x6 mil bolts front and rear of camchain tunnel. If the nuts are really badly mullered then you can in fact either weld a old sockett onto the nut using a stick welder or cut the bolts thru the cooling fins, I've only had to do this once, never going back to that breakers, there were lots of issues and they were the last ones to have that motor in bits..................
 Normally fairly easy to do

Bryanj:
There are def 12 and its beter to pull the cylinders as well or the base gasket will leak later

MIKE550/4:
right head and barrels are off  :D

realise its a clean up and rebuild with new gaskets , but have a couple of questions

how do you know condition of pistons, barrells,cylinder head etc

what do you guys do about barrels and the head to make it look good going back on, heard about bead blasting ?
really want to do this properly

also valve stem seals , would i have to strip out these before they would bead blast

right off to buy valve spring compressor,

let me know if i am the mark here guys

Navigation

[0] Message Index

[#] Next page