SOHC.co.uk Forums > CB350/400
Engine Strip - I'm nervous
Nurse Julie:
--- Quote from: waffey on January 16, 2020, 11:52:11 AM ---always take the advice of a nurse ;
Thanks Nurse Julie
--- End quote ---
Do you know what the piston to bore clearance is at present? It depends on what the clearance is as to what size over you need to go. It's no good going +. 50 if the bores are already worn up to near, or over . 50 already. I'm assuming the clearance is well within spec at present 🤔
waffey:
Nurse, nurse...….yes, its an assumption that the bores are ok, I need to somehow beg, borrow or steal a measuring device to check the internals.
next on my slop chit. I still cleaning bits and bobs and have to make a place for the frame which should be due back by the end of the month.
gotta work on the TL soon as well...….
Bryanj:
If you come past gloucester i will measure it for you
Nurse Julie:
--- Quote from: Bryanj on January 16, 2020, 06:50:47 PM ---If you come past gloucester i will measure it for you
--- End quote ---
Ditto.... But I doubt you will be passing Lincolnshire 😁😁😁
waffey:
Help, how do I remove the in neutral switch from the casing?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version