SOHC.co.uk Forums > CB350/400

HT lead markers

<< < (2/3) > >>

Orcade-Ian:
Thanks Piki and Julie,
Ordered 2 sets!

Ian

Trigger:
I found that these and any sticker don't like to stick to silicone rubber so, a cover of clear heat shrink does the job.


[ Guests cannot view attachments ]

Orcade-Ian:
Thanks Graham,
That’s a useful tip, I’ll try that - are those exhaust studs just bright zinc or stainless?
My outer sleeving was missing because of the bodge but I’ve just ordered some from Venhill.  It’s ever so slightly bigger in the bore than standard but at least it won’t end up like trying to fit a condom to an elephant - not that I ever have of course!

Ian

Trigger:

--- Quote from: orcadian on February 11, 2020, 09:01:12 PM ---Thanks Graham,
That’s a useful tip, I’ll try that - are those exhaust studs just bright zinc or stainless?
My outer sleeving was missing because of the bodge but I’ve just ordered some from Venhill.  It’s ever so slightly bigger in the bore than standard but at least it won’t end up like trying to fit a condom to an elephant - not that I ever have of course!

Ian

--- End quote ---

They are the old studs that have been re zinc plated  :o
Hilltop do the correct size sleeving at 7.5mm  ;)

Orcade-Ian:
Thanks Graham,
That’s the size that Venhill have too, I wasn’t sure that the original had 0.5mm diametral clearance, which only equates to 10 thou inside wall to HT lead clearance. 

Ian

Navigation

[0] Message Index

[#] Next page

[*] Previous page