SOHC.co.uk Forums > Project Board
Swing arm pivot bolt
Orcade-Ian:
I’m still confused,
Yes, early 400s had the foot pegs on the swing arm, but they were actually ON the arm between the pivot and the rear wheel spindle, not on the pivot. I still think that pivot pin you have with the grease nipple must be from something other than 350 or 400. I have both 350 and 400 bikes and will check tomorrow. I also think I have the pivot pin you need for a 400 - might even still have a 350 too.
Ian
Nurse Julie:
I was thinking that as well Ian... Yes, they are on the swing arm but not on the pivot bolt as you say.
Erwin83:
Ok. Would love to hear if you have the right one.
In this case, i can only conclude that indeed it must be from another CB with a wider frame and swingarm pivot. 500f maybe?
Strange because I am certain I only took apart 2x a CB400f...
Orcade-Ian:
Hi Erwin,
Just checked and the 350 and 400 are the same length - give or take a mm, but as you know, only the 350 has the grease nipple. I looked through my box of bits and can’t find a 400 one but I do have a spare 350 one complete with cup washers, nut and grease nipple.
If you are not in a rush, I’ll bring it over in May (it’s March tomorrow!) but otherwise I can post it.
Ian
SteveD CB500K0:
It’s Feb 29th tomorrow.
Sent from my iPhone using Tapatalk
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version