SOHC.co.uk Forums > Project Board
1978 CB550 K3 "running" restoration
SPR:
So .... started getting ready to do the fork seals and noticed this when I had removed the front wheel ... it would appear the disk has been rubbing on the fork leg at some point
The disk isn't warped - any ideas what to check when I get round to re assembly
Pic isn't great but you can see where it has been catching
Cheers
Simon
[ Guests cannot view attachments ]
hairygit:
Condition of wheel bearings, and check the tube nut is mounted the correct way on the wheel spindle.
Sent from my POT-LX1 using Tapatalk
SPR:
--- Quote from: hairygit on April 30, 2020, 10:46:11 AM ---Condition of wheel bearings, and check the tube nut is mounted the correct way on the wheel spindle.
Sent from my POT-LX1 using Tapatalk
--- End quote ---
Thanks - I know I'm showing my ignorance - but could you explain "tube nut"
Simon
hairygit:
On the front wheel spindle there is a long but/tube, if you need to replace the bearings it has to be removed to get the spindle out. It is entirely possible that a previous owner has refitted the tube nut the wrong way, which moves the entire wheel assembly slightly to the left (from sitting on the bike in the normal riding position) allowing a very slight contact between the disc and fork leg.
Sent from my POT-LX1 using Tapatalk
SPR:
--- Quote from: hairygit on April 30, 2020, 11:13:45 AM ---On the front wheel spindle there is a long but/tube, if you need to replace the bearings it has to be removed to get the spindle out. It is entirely possible that a previous owner has refitted the tube nut the wrong way, which moves the entire wheel assembly slightly to the left (from sitting on the bike in the normal riding position) allowing a very slight contact between the disc and fork leg.
Sent from my POT-LX1 using Tapatalk
--- End quote ---
Thanks - I'll check on reassembly if it is touching and then check what you have said
Cheers
Simon
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version