SOHC.co.uk Forums > Project Board

1978 CB550 K3 "running" restoration

<< < (12/38) > >>

Bryanj:
Well done, told you so(my wife tells me a dance goes with that!!)
Seriously you tacked one of the worst jobs so all good from here

SPR:
Bit more progress

Frame tidy up under the seat and new Continentals front and back

Cheers

Simon

SPR:
Quick question on Carb mixture screw

I'm just changing the gaskets with genuine ones and changed the rubber washer with the new one in the kit .....

It seems slightly smaller than the old ones coming out and does mean that when setting the screw the closed screwed in starting point is further in than it was before

Will this matter ? Is it that the old ones have squashed and widened / swollen ?

Bad pic shows two old ones top and new one below

[ Guests cannot view attachments ]

Thanks

Simon

Bryanj:
Thats just deformed in use mate, make sure the tiny washers gonbetween the spring and O ring

SPR:

--- Quote from: Bryanj on April 20, 2020, 06:42:55 PM ---Thats just deformed in use mate, make sure the tiny washers gonbetween the spring and O ring

--- End quote ---

Brilliant - thanks again

Yep got needle / spring / washer / o ring then screwed in ....

So it won't matter that the screw goes in further to a stop now ... before then winding out

Cheers

Simon

Navigation

[0] Message Index

[#] Next page

[*] Previous page