SOHC.co.uk Forums > CB350/400

Carb Float bowl O-rings

(1/3) > >>

Oggers:
Anyone know of the correct size for these things? Where to buy also. Mr Silver only does "kits". Only need the O rings as carbs are done. Could re-use I guess, but would prefer not to. Also, the ones I pulled off seem far too large! Copius amounts of gasket stuff to hold in place perhaps when refitting. 

Nurse Julie:
If you can wait until early next week, I will have a fresh supply of the float bowl O rings (Viton) in to sell on my ebay page. (but just send me a PM instead). Iv just fitted my last set to a set of bowls this morning. If the ones you have removed seem too large, they are probably nitril and have swollen due to the Ethanol in the fuel.

Moorey:
Viton 63mm x 2mm

Nurse Julie:

--- Quote from: Moorey on March 11, 2020, 02:19:22 PM ---Viton 63mm x 2mm

--- End quote ---
You got there before me Chris... I was just looking at my order and it's 67 x 2mm I have on order anyway 🙄🙄🙄🙄 So not for the 400 bowls anyway. Oh poo, now I have run out of both.

Moorey:

--- Quote from: Nurse Julie on March 11, 2020, 02:21:35 PM ---
--- Quote from: Moorey on March 11, 2020, 02:19:22 PM ---Viton 63mm x 2mm

--- End quote ---
You got there before me Chris... I was just looking at my order and it's 67 x 2mm I have on order anyway 🙄🙄🙄🙄 So not for the 400 bowls anyway. Oh poo, now I have run out of both.

--- End quote ---

Best order some more then.  :)  What do the 67mm ones fit.

Navigation

[0] Message Index

[#] Next page