SOHC.co.uk Forums > CB350/400

Carb Float bowl O-rings

<< < (3/3)

Nurse Julie:

--- Quote from: awrawr on March 12, 2020, 09:34:11 PM ---When you buy these, the suppliers specify only 2 dimensions- the length and the thickness. You need 63×2. There is no distinction between ID/OD. Nice and easy

--- End quote ---
It's not the length, it's the internal diameter (ID) x the thickness. All my suppliers only use ID x thickness. Anyways, to answer Oggers question its 63mm ID.

awrawr:
Yes, of course. You dont need to check with a ruler to see the error in my post. Brain fade. Sorry.

Oggers:
Nurse - well yes, and thanks for the confirmation. Plenty on Fleabay. Took the bowls off, gave them a clean, thought a bit, then gave them a wet and dry polish, then thought a bit more and got the polishing mop out. They now look very shiny and spiffing. I'll just have to bring the rest of the bike up to match now! Small ball bearing behind the choke lever cam looks a swine to re-install. Blob of grease I think........

Navigation

[0] Message Index

[*] Previous page