SOHC.co.uk Forums > CB750
Clutch slip
Bryanj:
With a fibre worn that bad i would suggest a full set of fibre and steel.
That plate gets wrecked when the centre outer plate is put on wrong, it only fits in certain places
Trigger:
New plates all round.
I would also fit a replacement lifter plate, new lifter bearing and do you have a double plate in the stack ?
Look for grooves in the surface of the plate, clutch and the center, clutch ;)
brodsord:
Thanks all for your reply’s.
Hi Trigger yes it has the double plate in the middle.
I’ve just sent Andy at good bits a message to see if he is still doing internet orders, he has an updated lifter in his web shop and a complete clutch kit.
Is the double metal plate specific to different models?
Thanks
Gray
Sent from my iPhone using Tapatalk
brodsord:
There’s no grooves I meant to add, the plates are smooth, they seem to have a diamond pattern etched in the surface
Sent from my iPhone using Tapatalk
brodsord:
--- Quote from: philward on April 28, 2020, 06:42:49 PM ---Mike Smith at 'good-stuff' (he is a dormant forum member I think) does this upgraded plate he uses for his racer - https://good-bits.co.uk/product/cb750-sohc-clutch-actuating-hub/
--- End quote ---
Thanks Phil, I’ve spoke with Andy at good bits a few months back, very helpful fella, I forgot about his shop so thanks for heads up
Sent from my iPhone using Tapatalk
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version