SOHC.co.uk Forums > CB500/550

Caliper orientation

<< < (2/2)

SpannerBrat:
Ka-Ja - If I understand your suggestion correctly, it doesn’t seem as simple as swapping them. The threads are different diameters. There’s also a “scoop” out of the casting at the hose entry point that allows the banjo to exit without fouling anything. Thanks for the link. Some interesting info. That’s certainly more effort than I’m hoping I’m going to have to get involved with.

Lobo - Thanks. Yes, I’ve heard that bleeding can be more troublesome in the linked calliper configuration. I’ve no particular issue running 2 full length hoses (one to each side) but before I buy anymore kit (another branded hose), is there any practical issue having the bleed nipple above (or below) the hose entry point?

ka-ja:
As I said, you could probably turn the caliper a little on one loose mountingbolt to get the bleed nipple upto the level of the inlet hose being careful not to eject the piston while doing it.

Navigation

[0] Message Index

[*] Previous page