SOHC.co.uk Forums > CB500/550
front wheel hub retainer removal
MIKE550/4:
update
had to chop it out in the end
2 more questions, how to remove bearings, how do you actually pull the bearings out?, it seems to sit flush with the hub,
also is there a part no for the plastic insert, part that sits inside the retainer
matthewmosse:
I ust ask Silvers for an oil seal and retainer - never know about part numbers. push a drift/nasty scewdriver thru from opposite side and leaver around at an angle, the inside of the hub is triangular and the tubular spacer between the bearings can be pushed to one side allowing you to drift the bearings out with hammer and drift/old nasty screwdriver ( I buy really cheap screwdrivers for this kinda job)
MIKE550/4:
had a look , spacer in between moves slightly , about 1mm of lip to hit ?
do i just try and work round and eventually it will pop out ... do this both ways ?
Bryanj:
With one brg out spacer will come out and use a bigger drift on tother side, when refitting new brgs only hit on outer race and dont forget the spacer:-
retainer 44643-300-000
seal 91252-300-003
MIKE550/4:
this front hub been a real pain now bearings will not budge, any other tips guys ?
want to get this fron wheel sorted and get both the wheels back on and have a rolling bike at last
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version