SOHC.co.uk Forums > CB750

clutch replacement

<< < (4/4)

ader:
I cracked the corner off the lifter plate, just into bolt hole, it seems to function ok. What is the potential damage if not replaced?

legin101:
now i have seen this infamous plate i can see why it happens, if the tension is taken off by all bolts at the same time then it will not break likewise when refitting take the tension by all bolts at the same time, now 3 bolt holes in good condition i would use a washer over the remaining hole and tighten to the specific torque.   that should be fine.

Bryanj:
Forget torque just snug by hand

Green1:
I ordered the lifter plate from Goodbits on the 5th June and it arrived on the 8th so great service.
I have finally got around to fitting it today after work. I would go out on it to test my new clutch but I'v hurt my shoulder and can't twist the throttle  :'(

Navigation

[0] Message Index

[*] Previous page