SOHC.co.uk Forums > CB350/400
Clutch pull still very hard...
mattsz:
--- Quote from: robvangulik on July 18, 2020, 06:33:01 PM ---
--- Quote ---So I don't have a clutch nut removal tool - I'll either have to buy or make one
--- End quote ---
That's very easy to make...
--- End quote ---
That looks even easier than what I was going to do! I was going to find a piece of pipe the right ID and grind one end to fit the nut, drill a hole in the other end to receive a tommy bar of whatever length I need.
I like the idea of something that takes a square drive, though - I can use it in an impact tool to rattle the nut loose if need be...
Navigation
[0] Message Index
[*] Previous page
Go to full version