SOHC.co.uk Forums > CB750
Hanging idle please help
K2-K6:
Push cable usually has no adjuster, so just fit and leave. But that one shouldn't give you a problem unless something is misplaced on brackets.
As it has an affect when you push the top of slides it may be that there's not a parity of the slide home position from assembly. Are you familiar with Bryan's bench synchronisation method? As that should remove an error like that if present.
Wenman:
--- Quote from: K2-K6 on July 03, 2020, 05:23:35 PM ---Push cable usually has no adjuster, so just fit and leave. But that one shouldn't give you a problem unless something is misplaced on brackets.
As it has an affect when you push the top of slides it may be that there's not a parity of the slide home position from assembly. Are you familiar with Bryan's bench synchronisation method? As that should remove an error like that if present.
--- End quote ---
No? Happy to whip the rack off and go through a proper sync.. where can I find that document please??
Thabsk
K2-K6:
http://www.sohc.co.uk/index.php/topic,17769.0.html
It should (it does) remove any discrepancy that inadvertently arises from reassembly of the carb rack to leave the slides in correct position relative to the single hand adjustable idle screw for setting overall tickover speed.
Afterwards, I'd not try anything with vacuum gauges until you've got the jetting more competently in range.
K2-K6:
This thread is worth a read too as it looks specifically at accommodations for running without air filter box etc.
http://www.sohc.co.uk/index.php/topic,22031.0.html
It'll be interesting to hear how you get on with it.
Wenman:
--- Quote from: K2-K6 on July 03, 2020, 06:04:13 PM ---This thread is worth a read too as it looks specifically at accommodations for running without air filter box etc.
http://www.sohc.co.uk/index.php/topic,22031.0.html
It'll be interesting to hear how you get on with it.
--- End quote ---
Thank you.. I think this is def the best starting point! I’ll be sure to get back and let you know how I get on!
Alan
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version