SOHC.co.uk Forums > CB750

F1 Ignition Switch Woes!

<< < (2/3) > >>

matthewmosse:
by the way in case you didn't know it you can get new connectors to go inside the connector block but the plastic blocks can be hard to get the right ones. Might end up being easyer than splicing wires :-\

Andy1976:
Try these guys
www.vehicleproducts.co.uk

Phatcol:
Thanks again guys;Andy especially; I've had a look at that site, and recon it might be better to wire up a new connector block that trying to guess the right size of connectors, and hoping for the best!
Cheers all, Col ;D

matthewmosse:
Hi, I use these suppliers a lot, genrally very fast good service. One word of advice though, the plastic casings won't fit with the standard Honda ones or indeed if it's the same as the 550 any of the switches / electrics mountings etc. However using a small technical screwdriver its quite easy to push back the latch on the back of each terminal  and remove all the metal connectors and replace them with new ones, for the ignition switch I think you'll be wanting 6 X female lock and latch 6mm blade terminals - I'd buy a few spares as they can often come appart on other parts of the bike as well - I'm thinking the red - red/white wires by the solinoid + fuse on cb550's here in paricular.

JonnyB:
I use their "Japanese Bullet" connectors - replaced most of them on my CB750, remember to get the insulating covers too.

Navigation

[0] Message Index

[#] Next page

[*] Previous page