SOHC.co.uk Forums > CB350/400
Brake master cylinder rebuild kit
mattsz:
Oh dear, my poor master cylinder thread...
mattsz:
I'm reassembling my brake system - I'm having a difficult time getting the brake switch junction back in place. It's really fighting me. This is the only way it seems to fit, slightly crooked and the tab on the right (of the photo) in contact with the fork clamp (see arrow). Is this right?
[ Guests cannot view attachments ]
mattsz:
Never mind... I don't know what happened, but when I went back to check it again, the junction/bracket turned freely when I loosened the mounting bolt...
robvangulik:
You probably forced it on its place by screwing it on the first time ;)
mattsz:
So, going to try bleeding the system tomorrow, keeping in mind all the advice above.
But: when doing this, do I need to have the rubber MC diaphragm in place at all? Or is that just to keep the fluid under control when the bike is in use?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version