Other Stuff > Misc / Open

Glaze busting

<< < (3/4) > >>

AndyD:
Thanks Dave,
I think that's the flex-hone tool and looks like it could be worth a go
The one I looked at was 60mm (hopefully Ok to suit 56mm bore) and was 240 grit - might try it out.

Cheers,
Andy

davefirestorm:
You could go quite a bit bigger as you can shove them up a much smaller hole but obviously more force needed and powerful drill,when I used one I held the single cylinder in lathe chuck and the flex-hone in a Jacobs chuck

AndyD:
Thanks Dave
That’s one thing I wasn’t sure about - how near to the bore size the hone needed to be and no idea where to find out
Cheers
Andy

Bryanj:
Needs to be bigger than bore to work propely but they are quite pricey, what i suggested(flap wheel) are a lot cheaper and fine for glaze busting. Used to be available at B&Q and many other places in various sizes and grades, used to get mine from our local engine parts supplier but they are few and far between now

Bryanj:
Look at ebay  313048407521

Navigation

[0] Message Index

[#] Next page

[*] Previous page