SOHC.co.uk Forums > CB500/550

550K1 - intake valve rocker arm issue on cyl#1?

(1/2) > >>

Erny:
Engine - CB550K1 / 1975

Today during break in ride I discovered cause of oil leak - tapper cap on intake (cyl#1) was not tightened fully (strange as I'm sure I tightened it after tapper adj.)
But why - because valve arm is "hitting" cap and making knocking noise :o

I did not have tappet feeler gauge with me, but just checking free play with hand it looked OK, maybe bit too much.
Comparing with intake on cyl#4 it is obvious that tappet adj.screw is "too deep", consequently arm too high and hitting cap (and also nearly hitting cyl head cover...)

See attached pics for comparison, incl. "hammered" points in cap

===>>>  Can someone provide idea what's wrong, why this tappet arm is so high? Worn arm? Worn cam? Or some other issue I should look for?
I'll check other tappets too, but seems only this one tappet/arm has this issue (I did not realised it before when adjusting tappets). Motor has not been opened yet from stock.

Note: Temporary I filed part of tappet cap (wide groove) to allow free arm movement, I still need to arrive home tomorrow (>150 miles), hope it will be fine like that. I'll check tappet adjustments tomorrow on cold engine before I go.

Johnwebley:
Both my Hondas can do this.

It's to big a gap and high revs.

It's safe to ride.

But check the gap

Sent from my SM-A750FN using Tapatalk

Erny:
This is what I'm afraid off - that there will be more damage, oil linked... :-\

Trigger:
This can happen for few reasons. I have found this many times due to :

Aftermarket tappet cover. Swap with another cover on the bike and see if it still does it.
Tappet cover over tightened with old 0 ring. New 0 ring and don't over tighten.
Worn rocker
Worn cam shaft
Tappet chipped 

Bryanj:
Could also be hardening gone on tip of valve so it indents and you have to screw adjuster father in, short valve stem on pattern valve.
Those would not cause hitting of cap but that is problably pattern cap not quite right, seen a few of those.
If all parts original most likely cause is cam lobe/rocker pad wear

Navigation

[0] Message Index

[#] Next page