SOHC.co.uk Forums > CB650
CB650 "Parts Bin Special"
SteveD CB500K0:
You can mix pictures in with your descriptive text if you host them externally.
There's a FAQ on the US site on how to do it:
http://forums.sohc4.net/index.php?topic=14605.msg93296#msg93296
matthewmosse:
I have a couple of cb550/k3 frames and a tank (same bike) that's got 1 pinhole that a petseal treatment missed plus a bad paintjob plus various other bits that might be of use. They are in mid Wales but could be dropped off somewhere en route to Sommerset or I could try finding out about postage
andy120t:
Cheers matthewmosse - have pm'd you on this.
SteveD - will try that too, should make the post flow better.
Andy
andy120t:
3. Engine Stripdown
The engine as received has had the alternator removed, the starter motor removed, the pick-up cover and pick-ups removed. All these parts and spares are in the boxes of bits but I
pae:
--- Quote from: andy120t on September 10, 2009, 10:35:00 AM ---Whilst I was here I noticed that there are only two rubber seals but eight possible locations. Is this normal? Why only 2 & what are they for?
--- End quote ---
They seal the hole where those bolts are. If you look, you'll see that those particular bolts go through to the 'outside' of the rocker assembly, so any oil going down those holes will just leak out. Hence, you need 'em all.
I bought a full gasket set, but only did a top end strip, so if it helps I might have some gaskets you could use. Probably find you'll need a full kit, or near as dammit, but shout if you do need any gaskets or seals. I have a new 'o' ring - the long wiggly one - that seals the rocker assembly to the head (~
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version