SOHC.co.uk Forums > CB350/400

Air box between inlet manifold & air filter housing not fitting correctly ?

<< < (2/4) > >>

taysidedragon:
Get a wooden stick or dowel long enough to reach through the large hole in the filter box and use it to push the air box and rubbers from inside.

Bryanj:
Ah, did my usual trick of only reading question and not looking at section its in.
Try not to do too many 400's as my arthritic fingers are too big

McCabe-Thiele (Ted):
Thanks I'll try that when I have fitted the new fuel line.
When I do the full strip down I also intend to change the front  right hand stud to a nut & bolt on the battery box fitting. That will make fitting the air filter/battery box so much easier.

McCabe-Thiele (Ted):

--- Quote from: Bryanj on August 28, 2020, 11:03:16 AM ---Ah, did my usual trick of only reading question and not looking at section its in.
Try not to do too many 400's as my arthritic fingers are too big

--- End quote ---

In my case as I am over 72 my skin is thinning also being  on Aspirin etc my skin just bruises and bleeds at the first opportunity. That said a good fit is worth the discomfort afterwards!!

Bryanj:
Just Asprin?
Add cadasartin, bisopropenanol, atorvastatin, metformin along with cocodamol+extra codeine and ibrupofen then B12 cos the metformin buggers that up and 2x exenatide injections(i was one of the guinea pigs for that one)

Apart from that im fine honest injun occifer

Navigation

[0] Message Index

[#] Next page

[*] Previous page