SOHC.co.uk Forums > CB500/550

need a seal part no

(1/3) > >>

MIKE550/4:
difficult to pin this down in words,

 steve d  you dont happen to have parts list photo for the front spindle do you ,

 best i can explain is where the chrome cover sits speedo side , under that chrome cover there is part which splits into 2, round the part that pushes out is a rubber seal, it looks like a ver small rubber band

550 k3

cheers if you can help

MIKE550/4:
nearest pic i could find , part 8, the middle section pushes out and there is a seal round the part that comes out, only gives part no for whole item, only need the seal ... anyone ?


http://www.motogrid.com/pages/parts/viewbybrand/parts.aspx

matthewmosse:
Silvers can normally find these bits over the phone without part numbers, might do the trick. Ps did you get the bearing retainer out in the end?

SteveD CB500K0:
Don't know if this helps, but...

MIKE550/4:
Yes its all stipped , have one side of bearing back in , had to chop it out in the end , still  got to do back wheel ,  big learning curve for me this but getting there

Navigation

[0] Message Index

[#] Next page